Connecting Roboclaw controller to myRIO

General discussion of using Roboclaw motor controllers
Denesh
Posts: 5
Joined: Mon Jul 02, 2018 7:17 pm

Connecting Roboclaw controller to myRIO

Postby Denesh » Fri Jul 13, 2018 1:51 pm

Hi
I'm using a 2X7A roboclaw controller .I would like to connect it to myrio and give commands on labview by receiving and sending data from myrio?
Please guide me on what is the procedure to do this.I have tried just connecting it via an usb cable.But my computer doesnt show roboclaw connected to myrio.

Looking forward
Regards
Denesh

User avatar
Basicmicro Support
Posts: 989
Joined: Thu Feb 26, 2015 9:45 pm

Re: Connecting Roboclaw controller to myRIO

Postby Basicmicro Support » Mon Jul 16, 2018 8:56 am

You need to install the Windows USB driver as well. Then you need to write VIs to talk to the Roboclaw or use the LabView device interface we wrote. But you will probably need to modify our interface for the MyRio.


Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests