Precharge Resistor, is soldering OK?

General discussion of the MCP motion controller product line
JorgeP
Posts: 11
Joined: Thu Nov 16, 2017 8:16 am

Precharge Resistor, is soldering OK?

Postby JorgeP » Fri Apr 27, 2018 10:23 am

I am using a pre-charge resistor across the contacts of a constant high current relay as shown in the lower middle of the photo (green resister and metal can). I've never wired one before and would like to know if I can solder the wire to the resistor (8 awg wire) or if I should use a crimp contact for it? 24V system at 73A max battery current, about 30-40A running current.

Do I need to use a wire size to the resistor that is high current or can 14-16AWG be safe enough?

Thank you in advance for your response.

Image

User avatar
Basicmicro Support
Posts: 1003
Joined: Thu Feb 26, 2015 9:45 pm

Re: Precharge Resistor, is soldering OK?

Postby Basicmicro Support » Mon Apr 30, 2018 9:23 am

The maximum current through the resistor is voltage/resistance. You can determine wire gauge from that but you will probably be able to use something quite small.

If its a perminent installation I'd solder and wrap the leads(heat shrink tubing).


Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 0 guests

cron